Overview
- The TB6600HG is a PWM chopper-type single-chip bipolar sinusoidal micro-step stepping motor driver.
- Forward and reverse rotation control is available with 2-phase, 1-2-phase, W1-2-phase, 2W1-2-phase, and 4W1-2-phase excitation modes.
- 2-phase bipolar-type stepping motor can be driven by only clock signal with low vibration and high efficiency.
Features
- Single-chip bipolar sinusoidal micro-step stepping motor driver
- Ron (upper + lower) = 0.4 Ω (typ.)
- Forward and reverse rotation control available
- Selectable phase drive (1/1, 1/2, 1/4, 1/8, and 1/16 step)
- Output withstand voltage: Vcc = 50 V
- Output current: IOUT = 5.0 A (absolute maximum ratings, peak)
- IOUT = 4.5 A (operating range, maximal value)
- Packages: HZIP25-P-1.00F
- Built-in input pull-down resistance: 100 kΩ (typ.), (only TQ terminal: 70ｋΩ(typ.))
- Output monitor pins (ALERT): Maximum of IALERT = 1 mA
- Output monitor pins (MO): Maximum of IMO = 1 mA
- Equipped with reset and enable pins
- Stand by function
- Single power supply
- Built-in thermal shutdown (TSD) circuit
- Built-in under voltage lock out (UVLO) circuit
- Built-in over-current detection (ISD) circuit
Wiring Diagram 1 (With Stand-Alone Breakout Board)
Wiring diagram with stand alone breakout board, such as mach3, USB CNC. It is suggested that ENA (enable) is left disconnected.
Wiring diagram (with stand alone breakout board)
Wiring Diagram 2 (With Arduino CNC Shield)
Wiring diagram with Arduino CNC shield. It is suggested that ENA (enable) is left disconnected.
Wiring diagram (with Arduino CNC shield)