NEW Re-ARM with RAMPS 1.6 - 3D PRINTER CONTROLLER Kit w/ Stepper motors DRV8825 and Endstops

(No reviews yet) Write a Review

Please read the Blog regarding this conversion HERE

Re-Arm with RAMPS 1.6 3D printer kit including:

  • 1x Panucatt Re-Arm 32 bit Board w/ Mini USB cable
  • 1x Ramps 1.6 board w/ jumpers and power connector
  • 3X Mechanical endstop switch w/ 40" cable
  • 5x DRV8825 stepper motor driver (upgraded from A4988, 2.5 A max current/phase
  • 5x Aluminum heat sink w/ 3M tape backing

New ZYLtech RAMPS 1.6 3D Printer Shield for Arduino


  • Larger bed MOSFET
  • Screw terminal power connection is safer and more reliable
  • Larger heat sink for more efficient heat dissipation 
  • Surface-mounted fuses and flush MOSFETS


  • 101.5mm x 60.5 (67.5 including reset button protrusion) x 30mm thickness overall
  • 4 layer PCB
  • Input Voltage - 12V
  • Power - 200W
  • Driver Support - A4988, DRV8825, TMC2130, TMC2208 (up to 5 stepper motors supported)

If you need a 1.4 board they are also available here:


Get the latest updates on new products and upcoming sales